Objective : To build the microcontroller of this project.
Procedure/Content :
1) Design circuit by using software
2) Print the design on the transparent paper
3) Stick the design with the PCB board
4) Drill and solder all the component
5) Test running the circuit with the program.
Picture 1 : PCB board
Picture 2: Aching PCB board PIC
Picture 3 : Soldering the PIC circuit complete
Picture 4: complete PIC circuit
Conclusion:
For the conclusion after we design the circuit diagram in the program software, we try on the PCB board to construct the circuit follow in the software. The software help a lot on the design PIC circuit, follow the PIC pin configuration and the port that we decide construct on the PCB board.
No comments:
Post a Comment