Objective : To build the output circuit for this project.
Procedure/Content :
1) Design circuit by using software
2) Print the design on the transparent paper
3) Stick the design with the PCB board
4) Drill and solder all the component
5) Test running the circuit with the program
Firstly design the ouput circuit by hand on the paper.
Picture 5 : Design the output circuit from the PIC
Design the valve circuit on proteus, for the inlet valve, it replace with lamp because there is no inlet valve on the software. When the lamp turn on it show the valve is on.
Picture 6 : diagram valve circuit in proteus
Picture 7 : pcb board
picture 8 : after aching the circuit
Picture 9 : complete soldering valve circuit
Picture 10: valve circuit components
Conclusion :
For the conclusion after we design the circuit diagram in the program software, try on the PCB board to construct the circuit follow in the software. The software help a lot on the design in valve circuit, follow the PIC pin configuration and the port that we decide construct on the PCB board.
No comments:
Post a Comment